Skip to content
 
Streamguard - Inlet Protection System

Streamguard - Inlet Protection System

Streamguard - Inlet Protection System

$115.17


FREE SHIPPING
SKU MM-SG.48.36

The Streamguard is a light duty drain filtration product used for storm grate filtration. This product is often used at construction sites, parking lots, and industrial commercial locations with a lower water volume rate with less sediment. This product hangs below the grate to filter out oil and sediment laden water. The suspended solids are captured by this streamguard prior to entering the inlet, which results in regulatory compliance.

The Streamguard is available in multiple size options. It removes 80% of sediment and debris, is easy to install, maintain and inspect.

 

MINIMUM ORDER REQUIREMENT: 5 UNITS

Product Specifics

  • Free Shipping
  • Need a Written Quote
           Request Online >
  • Questions? Call (800) 640-5537

Product Features

  • Available in 36” x 48” x 18” and  60” x 60” x 18”
  • Removes over 80% of sediment and debris
  • Absorbs and traps oil permanently
  • Meets 40 CFR 122.26 and NPDES compliance regulations
  • Easy to install, maintain and inspect

Shipping

  • FREE SHIPPING (standard ground, see map)
  • Call: (800) 604-5537 for pricing and ship times

Shipping estimates shown on the map pertain to this specific product only. Orders typically ship in 1-3 business days if the order is placed before 12:00 noon EST. Transit times displayed in the map are listed in business days, and are approximate. The day that the order is shipped is not counted as a transit day.

Installation and Maintenance Guidelines

Installation:

  • Remove grate from catch basin.
  • Clean dirt and debris from inlet ledge.
  • Insert Streamguard.
  • Reinstall grate. The top fabric portion should be pinched between the grate and the ledge.
  • Cut off excess fabric with a utility knife.

    • Maintenance:

    • Remove all accumulated sediment and debris from vicinity of unit after each storm event
    • After each storm event and at regular intervals, look inside the StreamGuard. If the unit has approximately 6 inches of accumulated sediment, it is recommended that the unit be replaced. In addition, if oil is seen floating and not absorbed, it’s time to replace the unit.
    • Dispose of unit in accordance with applicable federal, state and local environmental laws and regulations. The user is solely responsible for compliance with maintenance and disposal laws. Dandy Products or seller assume no responsibility for proper and improper maintenance and disposal.